Manual Disco Duro Externo

TRADEMARKS

*All other third-party brands and names are the property of their respective owners.

Apple, Macintosh and Mac are trademarks of Apple Computer. MS-DOS, Microsoft, Windows

95/98/NT/2000/ME/XP are trademarks of Microsoft Corporation. Table of Contents:

1. Introduction ......................................................................................................pg. 2

2. Specifications/Features ....................................................................................pg. 2

3. System Requirements .......................................................................................pg. 3

4. Hardware Installation .......................................................................................pg. 3

5. Disconnecting ...................................................................................................pg. 8

6. Creating A New Partition ..................................................................................pg. 9

7. Troubleshooting/FAQ .......................................................................................pg. 11

8. Warranty ............................................................................................................pg. 13

9. Contact ..............................................................................................................pg. 13

1. Introduction

The SATA/IDE-USB Adapter gives you the flexibility of connecting almost

any type of drive to your computer via USB. SATA, 3.5” IDE, 5.25” IDE, and

2.5” IDE drives are all supported and can be easily hot-swapped to your

system. The included external power adapter will allow you to power your

drives outside your system giving you the ability to quickly add or swap

between drives without opening your case. The SATA/IDE-USB adapter is

like 3 drive to USB adapters built into one!

2. Specifications/Features:

SATA/IDE-USB Adapter:

Specifications:

• Interface: SATA to USB 2.0

3.5” IDE to USB 2.0

2.5” IDE to USB 2.0

• Dimensions: 70 x 43 x 10 mm

• Cable Length: 92cm (36in)

Features:

• Transfer Rates Up to 12Mbps With USB 1.1

• Transfer Rates Up to 480Mbps With USB 2.0

• Easily add storage to any system with USB

• Supports ATA/ATAPI-7

• Supports LBA-48 Addressing

• Hot-swappable: Plug and play without rebooting!

23. System Requirements:

Intel Pentium II 350MHz-compatible or Apple G3 processor and greater

Microsoft Windows 98SE/ME/2000/XP or Mac OS 8.6 and greater

USB-equipped system

For USB 2.0 speeds, the system must support USB 2.0 specifications

4. Hardware Installation:

Preparing the hard drive:

For 3.5”/5.25” IDE drives: Set the hard drive jumpers to MASTER or

SINGLE DRIVE ONLY. Please refer to the

documentation included with your hard drive

for information on jumper settings.

For 2.5“ IDE drives: The MASTER configuration is typically jumperless.

For SATA drives: No jumpers necessary.

34

Installing the SATA/IDE-USB Adapter for internal use with 2.5” IDE Hard Drive:

1. Open computer case.

2. Connect the smaller 44-pin IDE connector of the SATA/IDE-USB

Adapter to the hard drive.

(The power will be supplied by the USB)

3. Connect USB connector of SATA/IDE-USB Adapter to an available

internal or external USB port.

4. Close computer case.

Installing the SATA/IDE-USB Adapter for internal use with 3.5”/5.25“ IDE Drive:

1. Open computer case and find an available 3.5”/5.25” bay.

2. Insert drive and

...