Silent Install Readme Note

==========================

Silent Install Readme Note

==========================

This note shows the different line commands to run unattended "silent" install/Uninstall(s) for the Broadcom NetXtreme Drivers and Management Applications installer.

NOTES:

======

- All commands are case sensitive

- User must "Run as Administrator" for Windows Vista when using "msiexec" for "silent" install/uninstall(s).

Silent Install from within the installer source folder:

setup /s /v/qn

Silent Upgrade from within the installer source folder:

setup /s /v/qn

Silent Uninstall:

msiexec /x "{9B34CC4C-E7FF-4AC8-B771-1D09612D6430}" /qn

Note: After silently uninstalling it is necessary to reboot the system before reinstalling this installer. If a reboot is not performed, BASP will not install correctly.

Silent Reinstall of the same installer:

setup /s /v"/qn REINSTALL=ALL"

Note: the "REINSTALL" switch should only be used if the same installer is already installed on the system. If upgrading an earlier version of the installer, please use "setup /s /v/qn" as listed above.

Silent Install by Feature on IA32 Platforms: Use ADDSOURCE to include any of the features listed below.

setup /s /v"/qn ADDSOURCE=Driversi32,BACSi32,BASPi32,SNMPi32,CIMi32"

Silent Install by Feature on AMD64/EM64T Platforms: Use ADDSOURCE to include any of the features listed below.

setup /s /v"/qn ADDSOURCE=Driversa64,BACSa64,BASPa64,SNMPa64,CIMa64"

The following line command will install the Broadcom drivers only on IA32 Platforms...

setup /s /v"/qn ADDSOURCE=Driversi32"

The following line command will install the Broadcom drivers only on AMD64 Platforms...

setup /s /v"/qn ADDSOURCE=Driversa64"

Note: The Broadcom device drivers are a required feature and will always be installed, even if not specifying with ADDSOURCE.

...