Valvulas Cilindro Compresor N° 1

Su función consiste siempre en la adquisición de votos en las elecciones como vía a la obtención de cargos públicos

Troubleshooting

G3600 Engines

BLB1-Up (Engine)

BKE1-Up (Engine)

BEN1-Up (Engine)

4ZS1-Up (Engine)

SAFETY.CAT.COM

i03991620

Important Safety Information

Most accidents that involve product operation, maintenance and repair are caused by failure to observe

basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous

situations before an accident occurs. A person must be alert to potential hazards. This person should also

have the necessary training, skills and tools to perform these functions properly.

Improper operation, lubrication, maintenance or repair of this product can be dangerous and

could result in injury or death.

Do not operate or perform any lubrication, maintenance or repair on this product, until you have

read and understood the operation, lubrication, maintenance and repair information.

Safety precautions and warnings are provided in this manual and on the product. If these hazard warnings

are not heeded, bodily injury or death could occur to you or to other persons.

The hazards are identified by the “Safety Alert Symbol” and followed by a “Signal Word” such as

“DANGER”, “WARNING” or “CAUTION”. The Safety Alert “WARNING” label is shown below.

The meaning of this safety alert symbol is as follows:

Attention! Become Alert! Your Safety is Involved.

The message that appears under the warning explains the hazard and can be either written or pictorially

presented.

A non-exhaustive list of operations that may cause product damage are identified by “NOTICE” labels

on the product and in this publication.

Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.

The warnings in this publication and on the product are, therefore, not all inclusive. You must

not use this product in any manner different from that considered by this manual without first

satisfying yourself that you have considered all safety rules and precautions applicable to the

operation of the product in the location of use, including site-specific rules and precautions

applicable to the worksite. If a tool, procedure, work method or operating technique that is not

specifically recommended by Caterpillar is used, you must satisfy yourself that it is safe for you

and for others. You should also ensure that the product will not be damaged or become unsafe by

the operation, lubrication, maintenance or repair procedures that you intend to use.

The information, specifications, and illustrations in this publication are on the basis of information that

was available at the time that the publication was written. The specifications, torques, pressures,

measurements, adjustments, illustrations, and other items can change at any time. These changes can

affect the service that is given to the product. Obtain the complete and most current information before you

start any job. Cat dealers have the most current information available.

When replacement parts are required for this

product Caterpillar recommends using Cat re-

placement parts or parts with equivalent speci-

fications including, but not limited to, physical

dimensions, type, strength and material.

Failure to heed this warning can lead to prema-

ture failures, product damage, personal injury or

death.

In the United States, the maintenance, replacement, or repair of the emission control devices and

systems may be performed by any repair establishment or individual of the owner's choosing.

RENR5910-06 3

Table of Contents

Table of Contents

Troubleshooting Section

Introduction

General Information ................................................ 4

Welding Precaution ................................................. 4

Electronic Service Tools .......................................... 4

Troubleshooting Data Sheet ................................... 8

Electronic System Overview

System Overview ................................................... 11

Component Location ............................................. 18

Engine Monitoring System .................................... 24

Diagnostic Capabilities ......................................... 25

Programmable Parameters ................................... 25

Electrical Connectors ............................................ 26

Configuration Parameters

Configuration

...